Low temperature scanning force microscopy of the Si(111)-(7x7) surface

A low temperature scanning force microscope (SFM) operating in a dynamic mode in ultrahigh vacuum was used to study the Si(111)- (7x7) surface at 7.2 K. Not only the twelve adatoms but also the six rest atoms of the unit cell are clearly resolved for the first time with SFM. In addition, the first measurements of the short range chemical bonding forces above specific atomic sites are presented. The data are in good agreement with first principles computations and indicate that the nearest atoms in the tip and sample relax significantly when the tip is within a few A of the surface.     

Air-breathing laminar flow-based microfluidic fuel cell

This communication reports the design and characterization of an air-breathing laminar flow-based microfluidic fuel cell (LFFC). The performance of previous LFFC designs was cathode-limited due to the poor solubility and slow transport of oxygen in aqueous media. Introduction of an air-breathing gas diffusion electrode as the cathode addresses these mass transfer issues. With this design change, the cathode is exposed to a higher oxygen concentration, and more importantly, the rate of oxygen replenishment in the depletion boundary layer on the cathode is greatly enhanced as a result of the 4 orders of magnitude higher diffusion coefficient of oxygen in air as opposed to that in aqueous media. The power densities of the present air-breathing LFFCs are 5 times higher (26 mW/cm2) than those for LFFCs operated using formic acid solutions as the fuel stream and an oxygen-saturated aqueous stream at the cathode ( approximately 5 mW/cm2). With the performance-limiting issues at the cathode mitigated, these air-breathing LFFCs can now be further developed to fully exploit their advantages of direct control over fuel crossover and the ability to individually tailor the chemical composition of the cathode and anode media to enhance electrode performance and fuel utilization, thus increasing the potential of laminar flow-based fuel cells.     

Active control of the depletion boundary layers in microfluidic electrochemical reactors

In this paper, we describe three methods to improve the performance of pressure-driven laminar flow-based microreactors by manipulating reaction-depletion boundary layers to overcome mass transfer limitations at reactive surfaces on the walls, such as electrodes. The transport rate of the reactants to the reactive surfaces is enhanced by (i) removing the depleted zone through multiple periodically-placed outlets; (ii) adding fresh reactants through multiple periodically-placed inlets along the reactive surface; or (iii) producing a spiraling, transverse flow through the integration of herringbone ridges along the channel walls. For approaches (i) and (ii), the network of microfluidic channels needs to be designed such that under the operating conditions used the right amount of boundary layer at each outlet or inlet is removed or replenished, respectively. Here, we report a set of design rules, derived with the help of a fluidic resistance circuit model, to aid in the design of appropriate microfluidic networks. Also, the actual enhancement of the performance of the electrochemical microreactor, i.e. chemical conversion efficiency, using multiple inlets, multiple outlets, or herringbone ridges is reported.     

Metastable States of small-molecule solutions

Metastable states such as gels and glasses that are commonly seen in nanoparticle suspensions have found application in a wide range of products including toothpaste, hand cream, paints, and car tires. The equilibrium and metastable state behavior of nanoparticle suspensions are often described by simple fluid models where particles are treated as having hard cores and interacting with short-range attractions. Here we explore similar models to describe the presence of metastable states of small-molecule solutions. We have recently shown that the equilibrium solubilities of small hydrogen-bonding molecules and nanoparticles fall onto a corresponding-states solubility curve suggesting that with similar average strengths of attraction these molecules have similar solubilities. This observation implies that metastable states in small-molecule solutions may be found under conditions similar to those where metastable states are observed in nanoparticle and colloidal suspensions. Here we seek confirmation of this concept by exploring the existence of metastable states in solutions of small molecules.     

Methanol dehydrogenation and oxidation on Pt(111) in alkaline solutions

Adsorption, dehydrogenation, and oxidation of methanol on Pt(111) in alkaline solutions has been examined from a fundamental mechanistic perspective, focusing on the role of adsorbate-adsorbate interactions and the effect of defects on reactivity. CO has been confirmed as the main poisoning species, affecting the rate of methanol dehydrogenation primarily through repulsive interactions with methanol dehydrogenation intermediates. At direct methanol fuel cell (DMFC)-relevant potentials, methanol oxidation occurs almost entirely through a CO intermediate, and the rate of CO oxidation is the main limiting factor in methanol oxidation. Small Pt island defects greatly enhance CO oxidation, though they are effective only when the CO coverage is 0.20 ML or higher. Large Pt islands enhance CO oxidation as well, but unlike small Pt islands, they also promote methanol dehydrogenation. Perturbations in electronic structure are responsible for the CO oxidation effect of defects, but the role of large Pt islands in promoting methanol dehydrogenation is primarily explained by surface geometric structure.